Samsung M017f Isp Pinout Info

To perform an ISP connection, you must solder jump wires to the following specific points on the motherboard: : Command signal point. CLK : Clock signal point. DAT0 : Data line 0 point. VCC (2.8V/3.3V) : Power supply for the eMMC. VCCQ (1.8V) : Input/Output power supply for the eMMC. GND : Ground point (any metallic shield or ground pad). Connection Setup

[Motherboard] [ISP Programmer] TP_CLK ---------------------> CLK (Pin 2) TP_CMD ---------------------> CMD (Pin 3) TP_DAT0 ---------------------> DAT0 (Pin 5) GND ---------------------> GND VCC (3.3V) -------------------> VCC (Only if board is unpowered) samsung m017f isp pinout

: Synchronizes data transfer between the programmer and the chip. CMD (Command) : Sends instructions to the eMMC. To perform an ISP connection, you must solder